|
CFM Performance: Product Lines: Yamaha Banshee
Aluminum Airbox | Coolant Bottle Bracket | Cooler | Front Lowering Kit | Rear Lowering Kit | Tie Rods
 (click image for larger photo)
| Yamaha Banshee Aluminum Airbox
Aluminum airbox manufactured by CFM-Performance. Get rid of that stock airbox with one difficult to install air filter. Our airbox features a unique elliptical design which gives you the benefit of vastly improved air flow through two easy to install filters while still protecting the filter elements from mud, dirt, and water. Our airbox will accept either UNI or K&N filters, 2 1/2" I.D. x 5" long. Available from CFM-Performance or directly from UNI or K&N. Virtually any carb can be used. If you use 26mm or 28mm Mikuni's, your stock air boots attach to our airbox. If you use 33mm, 34mm, or 35mm Keihen's, you can stretch your stock boots over these carbs or you can purchase a set of urethane air boots from us that are designed to fit Keihen carbs. Our slotted rear mounting bracket will allow you to use our airbox with or without reed spacers. A coolant bottle mounting bracket is also availableso you can run with or without it. This is your chance to own the best, most versatile Banshee airbox. Get maximum airflow and maximum engine protection with our elliptical airbox! |
(click image for larger photo)
| Yamaha Banshee Cooler
Original 20 fin billet aluminum engine cooler called the CFM Hydrocooler. Manufactured by CFM Performance. Don't be fooled by cheap imitations. The CFM Hydrocooler was designed and built by professionals specifically for your Yamaha. We employ the perfect balance of diameter, length, fin width, fin depth, fin spacing, and grade of aluminum to cool your Yamaha as efficiently as possible. Two coolers can be used on the same machine. To install, drain coolant. Remove a section of your stock radiator hose. Replace it with the CFM-Hydrocooler. Tighten the stainless steel hose clamps, provided to you at no additional charge. Refill coolant. This engine cooler will reduce your coolant return temperature by an average of 8-12 degrees depending on engine modifications and riding conditions. Not only is this safer, but cooler engine operating temperature equals more horsepower. |
 (click image for larger photo)
| Yamaha Banshee Front Lowering Kit
Billet aluminum front lowering kit manufactured by CFM Performance. Bolts to the top of your lower a-arms where the stock lower shock mount is. Lower shock is now mounted to the new bracket. Only takes a few minutes to install or remove. Will lower the front of your Banshee or Raptor 4". Also makes the front end 2" wider. Lower center of gravity for faster cornering. Perfect for trail riding, flat track, tt, or drag racing. |
 (click image for larger photo)
| Yamaha Banshee Rear Lowering Kit
Lower center of gravity for faster cornering. Perfect for motocross, trail riding, flat track, tt, or drag racing. Can be set at stock ride height, 2" lower, 3" lower, or 4" lower in just a few minutes. Easy to install or remove. You will need to use the bushings that are in your stock rear strut. |
 (click image for larger photo)
| Yamaha Banshee Tie Rods
Polished billet aluminum tie rods manufactured by CFM Performance. Made from billet aluminum for extremely high strength and light weight. Custom lengths available for customers with aftermarket a-arms. Available with or without wrench flats for no additional cost, to be specified by buyer at time of purchase. |
|
(click image for larger photo)
(click image for larger photo)
(click image for larger photo)
(click image for larger photo)