|
CFM Performance: Product Lines: Yamaha Blaster
(click image for larger photo)
| Yamaha Blaster Aluminum Airbox
This airbox allows for 50% more airflow than the stock airbox. We have seen 3-5 horsepower increases on modified Blasters just from installing this airbox. Get rid of that restrictive stock airbox and poorly designed filter element! To install our airbox you must cut the stock airbox out from the rear fenders. This does not reduce the strength of the rear fenders in any way. This airbox comes with a urethane boot that attaches the airbox to the carb, just like the one on a Banshee. At time of purchase buyer needs to tell us what size carb they are using so we can supply the correct size urethane boot. One size goes from 26-28 mm Mikuni. The other size goes from 33-35mm Keihen. The CFM Performance Blaster airbox uses a clamp on filter with a 2 1/2" I.D. UNI filter part number is UP-5245, available from any UNI dealer or directly from CFM Performance. If you prefer a K&N filter the part number is RD0720, also available from any K&N dealer or directly from CFM Performance. |
(click image for larger photo)
| Yamaha Blaster Front Lowering Kit
Billet aluminum front lowering kit. Bolts to the top of your lower a-arms where the stock lower shock mount is. Lower shock is now mounted to the new bracket. Only takes a few minutes to install or remove.Will lower the front of your Blaster 3 1/2". Also makes the front end 1" wider. Lower center of gravity for faster cornering. Perfect for trail riding, flat track, TT, or drag racing. |
(click image for larger photo)
| Yamaha Blaster Rear Lowering Kit
Aluminum rear lowering kit made by CFM Performance. Will lower the rear of your Blaster about three inches. Perfect for flat track, and drag racing. To install you must remove your stock airbox snorkel, or replace your stock airbox with a high performance CFM aluminum airbox, also available on ebay. This kit is installed where the upper rear shock is currently mounted. It will raise the upper shock mount. It can be installed or removed in just a few minutes. |
(click image for larger photo)
| Yamaha Blaster Scoop Kit
Aluminum scoop kit made by CFM Performance. Simple bolt on installation in just a few minutes. Will work with stock plastic or Maier plastic without cutting the fenders. This scoop kit will increase the airflow to the motor and help it run cooler. It comes with all of the necessary mounting hardware. No modifications to your Blaster are required. |
(click image for larger photo)
| Yamaha Blaster Tie Rods
Polished billet aluminum tie rods manufactured by CFM Performance. Made from billet aluminum for extremely high strength and light weight. Custom lengths available for customers with aftermarket a-arms. Available with or without wrench flats for no additional cost, to be specified by buyer at time of purchase. |
|
