|
CFM Performance: Product Lines: Yamaha Raptor 660
(click image for larger photo)
| Yamaha Raptor 660 Front Lowering Kit
Billet aluminum front lowering kit manufactured by CFM Performance. Bolts to the top of your lower a-arms where the stock lower shock mount is. Lower shock is now mounted to the new bracket. Only takes a few minutes to install or remove. Will lower the front of your Banshee or Raptor 4". Also makes the front end 2" wider. Lower center of gravity for faster cornering. Perfect for trail riding, flat track, tt, or drag racing. |
(click image for larger photo)
| Yamaha Raptor 660 Rear Lowering Kit
Lower center of gravity for faster cornering. Perfect for motocross, trail riding, flat track, tt, or drag racing. Will lower the rear of your Raptor about 4". Easy to install or remove. This kit replaces the stock strut that runs parallel to the swing arm. You will need to use the hardened steel bushings that are in your stock rear strut. |
(click image for larger photo)
| Yamaha Raptor 660 Tie Rods
Set of polished billet aluminum tie rods for a Yamaha Raptor or YFZ450. Made from billet aluminum for extremely high strength and light weight. Custom lengths available for customers with aftermarket a-arms. Available with or without wrench flats for no additional cost, to be specified by buyer at time of purchase. |
(click image for larger photo)
| Yamaha Raptor 660 Oil Tank
Aluminum oil tank built by CFM Performance. The most efficient way to cool the oil on your Raptor is by increasing the oil capacity. Our oil tank holds 10% more oil than any other aftermarket oil tank. It holds 1.25 more quarts than your stock oil tank. You will not find higher quality craftmanship in any other oil tank. Take a good look at some of the poor quality welds on other oil tanks! Ours also features precision machined fittings, and it is welded in a fixture for a perfect fit. Built with 5052 series aluminum for high strength and corrosion resistance. |
(click image for larger photo)
| Yamaha Raptor 660 Aluminum Airbox
Installing this airbox and rejetting your carbs will give you a 3-5 hp increase. We can help you with jetting specifications if necessary. Get rid of that difficult to install stock airfilter. Protect your engine with our easy to install high flow airbox and filter. Our airbox is designed to work with UNI or K&N TRX250R air filters. The TRX250R air filters allow 50% more airflow than any air filter available for the stock airbox. We sell UNI and K&N filters as well. |
(click image for larger photo)
| Yamaha Raptor 660 Cooler
Original 20 fin billet aluminum engine cooler called the CFM Hydrocooler. Manufactured by CFM Performance. Don't be fooled by cheap imitations. The CFM Hydrocooler was designed and built by professionals specifically for your Yamaha. We employ the perfect balance of diameter, length, fin width, fin depth, fin spacing, and grade of aluminum to cool your Yamaha as efficiently as possible. Two coolers can be used on the same machine. To install, drain coolant. Remove a section of your stock radiator hose. Replace it with the CFM-Hydrocooler. Tighten the stainless steel hose clamps, provided to you at no additional charge. Refill coolant. This engine cooler will reduce your coolant return temperature by an average of 8-12 degrees depending on engine modifications and riding conditions. Not only is this safer, but cooler engine operating temperature equals more horsepower. |
|
